Common fault causes and troubleshooting methods of simulated transportation vibration testing machine
1. Turn on the start switch without any display
1). Power plug or power cord is open
2). The fuse is blown.
3). The power switch is damaged.
Solution
1). Replace the plug or power cord
2). Replace the fuse
3). Replace the power switch
2. Adjust the speed knob and the transport station will not respond.
1). The connection cable of the control box and the transport station is not connected.
2). The speed control knob is damaged.
3). The speed control board is damaged.
4). Motor damage
Solution
1). From the new connection plug
2). Verify or replace the speed control knob
3). Verify or replace the speed control board
4). Check or replace
3 transport station action, but the tachometer always shows zero.
1). Tachometer damage
2). Sensor damage
3). Sensor position change
Solution
1). Replace the tachometer
2). Replace the sensor
3). Adjust the position of the sensor
4. The timer does not display
Timer burnout
Replace timer
5. After the timing is reached, the transport platform will continue to run.
1). Timer is damaged
2). The intermediate relay is damaged.
Solution
1). Replace the timer
2). Replace the intermediate relay
6 when the transport platform is running, there is a crash
Loose screws
Tighten the relevant screws
Gauze Swabs,Gauze Cotton Swab,Sterile Gauze Swabs,Absorbent Gauze Swab
Xinxiang Huaxi Sanitary Materials Co., Ltd. , https://www.huaximedical.com