After the operation is completed, clear and inspect the entire machine to remove the soil layer on the inner wall of the blade shield and the inner wall of the side plate in time to prevent the increase of load and exacerbate blade wear. When taking care, you must fill the butter on time.
When the maintenance tool is finished at the end of each year, the transmission should be cleaned and the gear oil should be replaced. The amount added must not exceed the dipstick marking line. Before working, check the height of the oil level and release the dirt deposited on the bottom of the gear box in time.
Replace the hammer claws or slings should be replaced in groups to maintain the dynamic balance of the knife shaft, the same group of hammer claws according to quality classification, the quality difference is not more than 25 grams, only the same quality hammer claw or throwing knife can be installed On the same roller.
After the operation is completed, clean and inspect the entire machine. Each bearing should be filled with butter, and all parts should be properly treated for rust prevention. The machine tool should not be placed in suspension and should be placed on a pre-padded object, parked in a dry place, and be loosened. No ground wheel should be used as a support point. Put in stock and padded it up with wooden blocks to keep the blade away from the ground to prevent deformation.
Natural Kidney Medicine,Vitamin C Minoxidil,Dinoprostone Api Powder,Yohimbine Hcl Powder
Xi'an Henrikang Biotech Co.,Ltd , https://www.henrikangbio.com