Spinach can be grown in autumn, winter and spring. Early sowing of the Yangtze River basin in the sowing season. Seed sowing from late August to early September. Sowing can be carried out earlier to July or until late September. Late autumn sowing is to be planted from early October to mid-November. From December to next spring Harvested. Variety selection Spinach according to the different shape of the leaf-shaped spinach and round leaf spinach two, sharp leaf spinach cold, round leaf spinach heat. Late autumn sowing spinach uses Japanese spring and autumn big leaves, Shanghai round leaf spinach, French spinach, joint No. 11 and other varieties. Before planting, the ploughing shall be conducted 10-12 cm deep after harvest, apply 50 kg of nitrogen, phosphorus, and potassium fertilizers per acre base, make a 1.8 meter wide (including ditch) rake, and sow 7.5 kg per acre. After sowing, 100 grams of water and 75 kilograms of weeding were used per acre with trifluralin. The soil in the field is relatively dry and watered immediately after sowing. After the seedlings were applied, top dressing was applied once in mid-November and mid-December. When the soil is dry, pour 1-2 times of water and apply water and light fertilizer. Harvesting and early sowing or high temperature, in the first half of December, once in the first harvest, harvest again in the next year from January to February; late sowing or low temperature, not harvested during the year, to the market from February to March of the following year Need a one-time harvest market. Each spinach can produce 1500-2000 kg of spinach. The spinach that leaves seeds and leaves is usually sown in late October. The harvest is harvested in February of the following year, so that the plant spacing becomes 10-12 cm, and the early bolting plants (mainly absolute male plants) are promptly removed. When the seed matures in early June, the seedlings are unplugged and accumulated for about 10 days to promote after-ripening.
An ear tag can be applied with an ear tag applicator (also called pliers), however there are also specially-designed tags that can be applied by hand.
Customized ear tag applicator is suitable for our ear tag,insure the ear tag is applied in righ way and reduce the loss rate.
If cattle are already identified with an Animal ID ear tag,do not attach a second Animal ID ear tag
- The female Animal ID ear tag has a lump on its printed face. To load, depress spring clip and insert female tag,holding the lump between thumb and forefinger.Position the tag so the lump faces out of the open end of the applicator.Failure to do so may result in damage to the electronic device.
- Slip male tag completely onto application pin
- Dip jaws of applicator holding tag into antiseptic or disinfectant solution.
- With the correct position located,apply the tag firmly,always with the male tag entering from the back(outside) of the ear.
- The Animal ID ear tag must be applied to the RIGHT(off side) ear as per illustration.
Animal Ear Tag Plier,Ear Tag Marking Pliers,Animal Ear Tag Making Pliers,Animal Remove Ear Tag Plier
BAOYING CHENGDONG SOCIETY WELFARE FACTORY , http://www.icareartag.com